Monitor Scan Tool Data

Connect scan tool to Data Link Connector (DLC).
Ignition "ON" & Engine "ON".
Press the brake pedal.
Monitor the "PRESSURE SENSOR" parameter on the Scan Tool.
Specification : Approx. 60bar -150bar (There is difference in displayed parameter according to braking force)
Whenever brake pedal is pushed down, is the pressure sensor's scan tool data changed?
YES
- Fault is caused by having been repaired and HECU memory was not cleared.
  Clear the DTC and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.