FixVault
Home › Kia › 2009 › Rio Base, Automatic › Repair and Diagnosis › Heating, Ventilation & A/C (HVAC) › HVAC Control Systems › Blower Controls › Blower Unit › Replacement

Blower Unit: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad. Refer to CRASH PAD .
  3. Disconnect the connectors from the fresh and recirculation actuator, the blower motor and power Mosfet.
  4. Remove the cowl crossbar assembly.
  5. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
    Fig 1: Identifying Blower Unit And Screws
    G04863899Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Make sure that there is no air leaking out of the blower and duct joints.
  6. Install in reverse order of removal.
About FixVault