| The disc becomes stuck or blocked. |
- Press the Stop / Eject button to release the disc.
- The player will attempt to eject the disc up to three times performing the Auto-Reload function.
- Once the Auto-Reload function is complete, press the Stop/Eject button again to release the disc from the player.
- If a disc is still stuck or blocked in the RSE unit, turn the ignition off and then on again to reset the RSE unit.
|
| There is no audio in the headphones. |
- Verify that the headphone is equipped with batteries, and that the batteries are changed.
- Insert or replace 2 AAA batteries to resume headphone function.
|
| The RSE does not work. |
- Press the PLAY button. If the display does not show "NO DISC", then there is no power.
- Check the power connection and the fuse.
- Turn the vehicle ignition off and back on to reset the RSE.
|
| The remote control does not work. |
- Make sure you are pointing the remote control at the face of the RSE at a 45° angle.
- Change the battery. [Device requires one(1) CR2025 battery.]
- Use the control buttons on the RSE display panel.
|
| Continue receiving an [O] when a button is pressed. |
Invalid button press. The function you are trying to perform is not available. |
| RSE has no sound, display, illumination at all. |
- If ,when connected to power supplier, RSE unit works well, check the connector. |
| Spring in the latch is missed. |
- Re-assemble spring with latch. |
| Mechanism cannot read the disc. |
- Check if the disc has some scratches or pits.
- In case the disc is stuck, after doing power off reset by pulling both audio fuses, wait 5 minutes an reinsert the fuses with key off. After turning on the ignition, press the eject key again.
|
| Audio is not interfaced with RSE. |
- Check the connection between Audio and RSE through multimeter.
- And measure the keydata line of the RSE and verify that 5 volts is coming out.
|