Inspection Procedure
- PREPARATION
Refer to PREPARATION OF INSPECTION .
- CHECK THE SEAT BELT BUCKLE SWITCH (BS)
- Measure current between the terminal 2 of BS and 69 (68) of SRSCM harness connector.
specification (current) : 12 ~ 17 mA (Buckled status) , 4 ~ 7 mA (Unbuckled status)
- Is the measured current within specification?
YES
- Go to next step.
NO
- Replace the BS.
- Measure current between the terminal 2 of BS and 69 (68) of SRSCM harness connector.
- CLEAR THE DTC AND CHECK THE VEHICLE AGAIN
Refer to CLEAR THE DTC AND CHECK THE VEHICLE AGAIN .