Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect scantool and select "Diagnostic Trouble Codes(DTCs)" mode.
2. Using a scantool, clear the DTC.
3. Operate the vehicle according to DTC DETECTING CONDITION CHART. (Start and drive vehicle in gear, maintaining vehicle speed at or above 10kmh. (6.2mph))
4. Using a scantool, check if any DTCs are present.
5. Are any DTCs present?

   YES 

   • Go to the appropriate troubleshooting procedure.

   NO 

   • System performing to specification at this time.