FixVault
Home › Kia › 2012 › Optima LX, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 66 (4WD Control System Diagnosis) › DTC P0602: Control Module Programming Error › Scantool Diagnostics › Monitor Scantool Data

Monitor Scantool Data

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scantool to Data Link Connector (DLC)
  2. IG key "ON", Engine "ON".
  3. Warm up the engine to normal operating temperature.
  4. Monitor diagnostic trouble code and present of trouble code.
  5. Are any DTCs present?
  6. Is the same DTC detected again?

    YES 

    • Substitute with a known-good "4WD-ECU" and check for proper operation. If the problem is corrected, replace "4WD-ECM" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • Check Mechanical problem of Transfer Case

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or "4WD-ECU" s connector or was repaired and "4WD-ECU" memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
About FixVault