Monitor Scantool Data
WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scantool to Data Link Connector (DLC)
- IG key "ON", Engine "ON".
- Warm up the engine to normal operating temperature.
- Monitor diagnostic trouble code and present of trouble code.
Using a scantool, Check if the same DTC re-sets after clearing DTC.
- Are any DTCs present?
YES
- Substitute with a known-good "Coupling" and check for proper operation. If the problem is corrected, replace "Coupling" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.