FixVault

Verification Of Vehicle Repair

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.