FixVault
Home › Kia › 2012 › Optima LX, Automatic Trans › Repair and Diagnosis › External Pages › Different variant/trim › Section 25 (Smart Key System - HEV) › Repair procedures › Inspection › Antenna Status Check

Antenna Status Check

WARNING: This page is about a different variant/trim than selected.
  1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel.
  2. Select the "Antenna Status Check".
    Fig 1: Display - ID Resister And Inspection/Test
    G08309056Courtesy of KIA MOTORS AMERICA, INC.
  3. After IG ON, select the "Antenna Status Check".
    Fig 2: Display - Antenna Status Check Screen
    G08309057Courtesy of KIA MOTORS AMERICA, INC.
  4. Set the smart key near the related antenna and operate it with a GDS.
    Fig 3: Display - Interia Antenna 1 Screen
    G08309058Courtesy of KIA MOTORS AMERICA, INC.
    Fig 4: Display - Completed Message Of Interia Antenna 2 Screen
    G08309059Courtesy of KIA MOTORS AMERICA, INC.
  5. If the smart key runs normal, the related antenna, smart key(transmission, reception) and exterior receiver are normal.
  6. Antenna status
    1. INTERIOR Antenna 1
    2. INTERIOR Antenna 2
    3. Trunk antenna
    4. BUMPER/Antenna
    5. DRV_DR Antenna
    6. AST_DR Antenna
About FixVault