Power Circuit Inspection

Check Voltage
1. IG "OFF" and disconnect Cooling fan module connector.
2. IG "ON".
3. Measure voltage between power supply terminal of Cooling fan module harness connector and chassis ground.
  Specification : Approx. 12V
  
  Fig 1: Measuring Voltage Between Power Supply Terminal Of Cooling Fan Module Connector & Chassis Ground
  Courtesy of KIA MOTORS AMERICA, INC.
  
  Fig 2: Cooling Fan Controller Connector End View
  Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured voltage within specification?
  YES
  - Go to "CONTROL CIRCUIT INSPECTION " procedure.
  NO
  - Check if cooling fan fusible link 60A is open or not installed.
  - Check if cooling fan relay is not installed or faulty
  - Check if the line between cooling fan relay and Cooling fan module is open.
  - Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.