FixVault
Home › Kia › 2013 › Soul Base, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 55 (Supplemental Restraint System Control Module (SRSCM) & Sensors) › Passive Occupant Detection System (PODS) › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PODS equipped seat cushion assembly. Refer to SEAT .
  2. Install the front passenger seat assembly.

    Refer to SEAT .

  3. Reconnect the battery negative cable.
  4. After installing the PODS, confirm proper system operation:
  1. Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS does not require suppression and the passenger airbag is enabled.

NOTE: Be sure to perform PODS reset with scan tool after replacing PODS equipped seat cushion.
About FixVault