DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy	Case1	Controller malfunction check failure of controller operation	Poor connection or damaged harness Unstable Power Faulty PCM/ECM
DTC Strategy	Case2	Knock Acquisition check
Enable Conditions	Case1	10V < Battery voltage < 16V Heater PWM > 1.56% Sensor operative readiness detected tip temp > 630 °C or 30 sec after dew-point exceeded
Enable Conditions	Case2	Engine speed > 32rpm
Threshold Value	Case1	Error bit information from H/W circuit
Threshold Value	Case2	Integrity of the knock acquisition is not correct
Diagnostic Time	Case1	5 sec.
Diagnostic Time	Case2	200 revs
MIL On Condition		2 Driving Cycles