Repair Procedures: Replacement

WARNING: This page is about a different car, the 2013 Hyundai Tucson and 2012 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery terminal.
Remove the crash pad. (Refer to CRASH PAD )
Remove the cowl cross bar assembly. (Refer to CRASH PAD )
Remove the heater and blower unit (Refer to CRASH PAD )
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.

Fig 1: Identifying Blower Unit On Heater Unit (1 Of 2)
Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Blower Unit On Heater Unit (2 Of 2)
Courtesy of HYUNDAI MOTOR CO.

NOTE: Make sure that there is no air leaking out of the blower and duct joints.
Installation is the reverse order of removal.