FixVault
Home › Kia › 2015 › Forte LX, Automatic Trans › Repair and Diagnosis › Engine Performance › System › Engine Control System Diagnosis (1 Of 2) - 1.8L › DTC P0135: O2 Sensor Heater Circuit (Bank 1/Sensor 1) › Wiring Inspection › Control Circuit Inspection

Control Circuit Inspection

  1. Ignition "OFF"
  2. Disconnect HO2S connector.
  3. Ignition "ON" & Engine "OFF"
  4. Measure voltage between Heater Control terminal of the HO2S harness connector and chassis ground.

    Specification:  Approx. 2.5V

  5. Is voltage within the specification?

    YES 

    NO 

    • Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
About FixVault