Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
Adjust the ignition lock switch.
1. In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.
  Standard Gap Range:
  
  3 ~ 4 mm (0.1181 ~ 0.1575 in.)
2. Tighten the nut (B) with the specified torque.
  Tightening Torque:
  
  7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
  
  Fig 1: Locate Ignition Lock Switch Installing Nuts
  Courtesy of KIA MOTORS AMERICA, INC.