Component Inspection

■ Clutch Switch Check 

1. IG OFF.
2. Disconnect the clutch switch connector.
3. Measure resistance between power terminal and signal terminal of the clutch switch connector.

   Specification: 

   Approx. below 1Ω (In case of pressing the clutch switch)

   Approx. ∞ Ω (In case of not pressing the clutch switch)

4. Is the measured value within specifications?

   YES 

   • Fault might be intermittent caused by poor connection in clutch switch harness and/or HECU's connector.

   NO 

   • Substitute with a known-good clutch switch and check for proper operation. If problem is corrected, replace clutch switch and then go to "Verification Of Vehicle Repair" procedure.