Repair Procedures: Installation

NOTE:

Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply engine oil to the injector O-ring.
Do not use already used injector O-ring again.
Do not use already used bolt again.
When insert the injector, be careful not to damage the injector tip.

NOTE: Remove the installation high pressure fuel pipe flange nut from the high pressure fuel pipe with the special service tool [SST No.: 09314-3V100]

Install in the reverse order of removal.
Delivery Pipe Mounting Bolt:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

High Pressure Fuel Pipe Flange Nut:

26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)