FixVault
Home › Kia › 2016 › Sorento L › Repair and Diagnosis › External Pages › Different variant/trim › Section 36 (Engine Control System - 3.3L) › Injector › Repair Procedure › Installation

Repair Procedure: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Combustion Seal, Rubber Washer, Support Disc, O-Ring
G11872183Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
  • Do not reuse the used injector fixing clip.
  • Install the component to the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
  • Do not reuse the used bolt.
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the rounded edge (A) part should be facing the cylinder installation part and the angulated edge (B) part should be facing the injector body part.
Fig 2: Locate Rounded Edge
G11872184Courtesy of KIA MOTORS AMERICA, INC.
CAUTION: Do not reuse the combustion seal.
  1. Install in the reverse order of removal.
About FixVault