Repair Procedure: Installation

WARNING: This page is about a different variant/trim than selected.

Check that the shift lever is placed in the "N" position
Install the inhibitor switch (A).
NOTE: Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.

Fig 1: Locate Inhibitor Switch
Courtesy of KIA MOTORS AMERICA, INC.
Install the manual control lever (A).
NOTE: Lightly tighten the manual control lever nut so that necessary adjustments can be made.

Fig 2: Locate Manual Control Lever
Courtesy of KIA MOTORS AMERICA, INC.
Align the hole (B) in the manual control lever with the "N" position hole (A) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).

Fig 3: Inserting SST Inhibitor Switch Guide Pin (09480-A3800)
Courtesy of KIA MOTORS AMERICA, INC.
Tighten the nut (A) and bolts (B) to the specified torque.
Tightening Torque:
1. 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
2. 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Fig 4: Locate Inhibitor Switch Nut And Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Remove the SST (09480-A3800) from the adjusment hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
Tightening Torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 5: Locate Inhibitor Switch Connector And Nut
Courtesy of KIA MOTORS AMERICA, INC.
Install the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Install the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")