Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-terminal (A) on the magnet switch assembly.

Courtesy of
After loosening the screws (A), detach the magnet switch assembly (B).

Courtesy of
Loosen the through bolts (A).

Courtesy of
Remove the brush holder assembly (A), armature assembly (B) and yoke assembly (C).

Courtesy of
Remove the gasket sheet (A) and lever stop (B).

Courtesy of
Remove the reducer assembly (A) and lever (B).

Courtesy of
Press the stopper (A) using a socket (B).

Courtesy of
After removing the stop ring (A) using stop ring pliers (B).

Courtesy of
Disconnect the stopper (A), overrunning clutch (B) and internal gear (C).

Courtesy of

NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).

Courtesy of
Reassembly is the reverse of disassembly.