Component Inspection

IG Key "OFF".
Disconnect HECU connector.
Measure resistance between Pin No. 1 (Power) terminal and Pin No. 2 (Signal) terminal of the Front RH Wheel Speed Sensor. (Component Side)
Specification: Approx. 475.9 kΩ

Courtesy of
Is the resistance of front RH wheel speed sensor similar as shown above?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace wheel speed sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.