Repair Procedures: Removal: Notes

1. Remove the tire.

   (Refer to "TIRE .")

2. Remove the screw with torx driver (A).
   CAUTION:

   • When installing the bead brake, make sure that it does not come in contact with the TPMS sensor.
   • Be careful not to damage the TPMS sensor when installing the bead brake near the TPMS sensor.

   Courtesy of

3. Remove the sensor body (A) from the valve (B) in the direction of the arrow.

   Courtesy of

4. Use the valve mounting tool to pull out the valve until it is entirely out of the lower hole.

   Courtesy of

   NOTE: Cut the rubber at the bottom of valve with a knife.

   Courtesy of

5. Apply lubricant to the surface of the valve, and then mount it through the valve hole of the wheel.
   NOTE: We recommend using regular soapy water as lubricant.

   Courtesy of

   CAUTION:

   • The TPMS sensor valve bottom is not properly sealed if it is not fully mounted on the wheel, as shown in the following figure:

   Courtesy of

   • Make sure that the valve body is pulled entirely through the hole.

   Courtesy of

6. Apply soapy water or lubricant to the upper/lower bead section of the tire.

   Courtesy of

7. In order to mount lower the beads, place the TPMS sensor at 5 o'clock, starting from the head of the tire replacement equipment.

   Courtesy of

8. Rotate the rim clockwise and press tire towards 3 o'clock to mount the lower beads.
   CAUTION:

   • Mount the tire on the wheel. Make sure that the beads touch the edge of the rim behind the sensor (towards 6 o'clock).

   Courtesy of

9. In order to mount the upper beads, press the tire towards 3 o'clock and turn the rim clockwise.

   Courtesy of

10. Inject air into the tire until the beads are in the correct position.

    Courtesy of

11. Adjust the tire pressure according to the recommended tire pressure for the vehicle.
12. If the TPMS sensor malfunctions, you must perform TPMS sensor learning. Replace any faulty sensors and perform TPMS sensor learning.

Diagnosis procedure by using diagnostic device 

Use as service information for diagnosis methods by using diagnosis device, the main contents are as follows:

1. Connect self-diagnosis connector (16 pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2. Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.