Check Oil Pressure Control Valve Operating State
- Ignition "OFF".
- Disconnect the Oil Pressure Solenoid Valve connector.
- Apply power to Pin No. 1 (Fuse-SENSOR2) and connect ground to Pin No. 2 (control) terminal of Oil Pressure Solenoid Valve. (Component Side)
Specification: Operating sound is heard
- Does the Oil Pressure Solenoid Valve operate properly?
YES
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the Oil Pressure Sensor and go to "Verification Of REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the Oil Pressure Solenoid Valve and go to "Verification Of REPAIR " procedure.