Repair Procedures: Installation
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
- Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque:
8.0 - 12.0 N.m (0.8 - 1.2 kgf.m, 5.9 - 8.8 lb.ft)
- Install the crash pad.
(Refer to Body - "MAIN CRASH PAD ASSEMBLY ")
- Connect the passenger airbag connector.
- Tighten the passenger airbag mounting bolts.
Tightening torque:
8.0 - 12.0 N.m (0.8 - 1.2 kgf.m, 5.9 - 8.8 lb.ft)
- Reinstall the glove box housing.
(Refer to Body - "GLOVE BOX HOUSING ")
- Reconnect the battery negative cable.
- After installing the passenger airbag (PAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.