Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ").
NOTE: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the KDS/GDS after completion of "Release Residual Pressure in Fuel Line" work.
Remove the Intake Manifold (Refer to REMOVAL AND INSTALLATION ).
Remove the injector foam (A).

Fig 1: Removing Injector Foam
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Fig 2: Disconnecting Rail Pressure Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.