FixVault
Home › Kia › 2017 › Forte5 EX › Repair and Diagnosis › External Pages › Different car › Section 64 (Engine Control System - 2.0L GDI) › Engine Control Module (ECM) › Repair Procedures › Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Remove the battery. (Refer to Engine Electrical System - "BATTERY ")
  3. Disconnect the ECM Connector (A).
  4. Remove the mounting bolts (B) and then remove the ECM bracket assembly (C).
    Fig 1: Disconnecting ECM Connector
    G12162378Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the mounting nuts (A), and then remove the ECM (B) from the ECM bracket assembly.
Fig 2: Removing ECM Mounting Nuts
G12162379Courtesy of KIA MOTORS AMERICA, INC.
About FixVault