Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Install in the reverse order of removal.
- Adjust the ignition lock switch.
- In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.
Standard Gap Range:
3 - 4 mm (0.1181 - 0.1575 in.)
- Tighten the nut (B) with the specified torque.
Tightening Torque:
7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb.ft)
- In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.