Repair Procedures: Installation
NOTE:
- Do not use already used injector fixing clip again.
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
- Apply engine oil to the injector O-ring.
- Do not use already used injector O-ring again.
- Do not use already used bolt again.
- When insert the injector, be careful not to damage the injector tip.
- Install in the reverse order of removal.
Delivery pipe mounting bolt:
18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb.ft)
High pressure fuel pipe mounting nut:
26.5 - 32.4 N.m (2.7 - 3.3 kgf.m, 19.5 - 23.9 lb.ft)