CAN Line Inspection

INSPECTION PART - ECM AND TCM CONNECTORS INSPECTION

Inspection Part: CAN Line Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the Battery (-) Cable. Disconnect the Electrical Connector(s) from the component.	ECM Connector	55 (P-CAN High)	TCM Connector	44 (P-CAN High)	Approx. below 1 Ω
	ECM Connector	77 (P-CAN Low)	TCM Connector	45 (P-CAN Low)	Approx. below 1 Ω

Good	Go to "Component Inspection " procedure.
No Good	Repair as necessary and then go to "Verification Of Repair " procedure.