Power Circuit Inspection
- Ignition "OFF"
- Refer to ELECTRIC WATER PUMP (EWP) and disconnect EEWP connector.
- Ignition "ON"
- Measure voltage between Pin No. 7 (Power) terminal of EEWP harness connector and chassis ground.
- Measure voltage between Pin No. 2 (ON/Start Input) terminal of EEWP harness connector and chassis ground.
Specification : B+
- Is measured value within specification?
YES
- Go to "Ground Circuit Inspection " procedure.
NO
- Repair open or short in power circuit, and then go to "Verification of Vehicle Repair " procedure.