Repair Procedures: Removal

Remove the battery and the battery tray.
(Refer to "CHARGING SYSTEM " .)
Remove the under cover (A).
Tightening Torque:

6.9-10.8 N.m (0.7-1.1 kgf.m, 5.1-8.0 lb-ft)

Fig 1: Locating Under Cover
Courtesy of KIA MOTORS AMERICA, INC.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "HYDRAULIC SYSTEM (FLUID) " )
Remove the air breather hose (A).
Remove the valve body cover (B).
Tightening Torque:

13.7-15.7 N.m (1.4-1.6 kgf.m, 10.1-11.6 lb-ft)

CAUTION: Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

Fig 2: Removing Air Breather Hose
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Remove installation bolts in the engine room first and then remove others under the vehicle.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening Torque:

9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 lb-ft)

Fig 3: Locating Oil Temperature Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the solenoid valve (B) after removing the solenoid support (A).

Fig 4: Removing Solenoid Valve

Courtesy of KIA MOTORS AMERICA, INC.