Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the under cover.
(Refer to "ENGINE ROOM UNDER COVER ")
Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.
Tightening torque:

33.3 - 43.1 N.m (3.4 - 4.4 kgf.m, 24.6 - 31.8 lb.ft)

Fig 1: Locating ATF Drain Plug
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: The existing ATF drain plug gasket must be replaced with new one. (Do not reuse it.)
Remove the battery and battery tray.
(Refer to "BATTERY ")
Remove the wiring bracket (A) and the air breather hose (B).
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 2: Locating Wiring Bracket & Air Breather Hose
Courtesy of KIA MOTORS AMERICA, INC.
Lift the vehicle after loosening valve body cover upper bolts.
Remove the valve body cover (A) by loosening bolts.
Tightening torque:

11.8 - 13.7 N.m (1.2 - 1.4 kgf.m, 8.7 - 10.1 lb.ft)

Fig 3: Locating Valve Body Cover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the solenoid valve harness (A) and oil temperature sensor (B) after removing the bolts.
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 4: Locating Solenoid Valve Harness & Oil Temperature Sensor With Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Remove solenoid valve support bracket (A).
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 5: Locating Solenoid Valve Support Bracket
Courtesy of KIA MOTORS AMERICA, INC.
Remove the line pressure control solenoid valve (A).

Fig 6: Locating Line Pressure Control Solenoid Valve

G12170729

Courtesy of KIA MOTORS AMERICA, INC.