Signal Circuit Inspection
- Ignition "OFF".
- Disconnect APS and ECM connector.
- Measure resistance between Pin No. 6 (APS.2 Signal) and Pin No. 4 (APS.1 Power) terminal of APS harness connector.
- Measure resistance between Pin No. 6 (APS.2 Signal) and Pin No. 5 (APS.2 Power) terminal of APS harness connector.
Specification: ∞ (infinite)Ω
- Is the measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair as necessary and go to "VERIFICATION OF REPAIR " procedure.