ECM Neutral Mode procedure (With Immobilizer)

• After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.

[If installing a used ECM] 

1. Perform "ECM Neutral Mode" procedure using KDS/GDS.

   (Refer to "Body Electrical System - "Immobilizer System -  Repair Procedures  ") 

2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS/GDS.

   (Refer to "Body Electrical System - "Immobilizer System -  Repair Procedures  ") 

   [If installing a new ECM] 

   Perform "Key Teaching" procedure using KDS/GDS.

   (Refer to "Body Electrical System - "Immobilizer System -  Repair Procedures  ")