Verification of Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect KDS/GDS to Data Link Connector(DLC), and monitor "Diagnostic Trouble Codes(DTC)".
2. Clear all DTCs in the system with KDS/GDS.
3. Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
4. Monitor "Diagnostic Trouble Codes(DTC)" with KDS/GDS and verify that any DTC is stored.
5. Verify that the DTC is cleared and system operates correctly.

Good 

• Problem is corrected and the system operation performs to specification at this time.

No Good 

• Go to applicable troubleshooting procedure.