FixVault
Home › Kia › 2018 › Sorento SX, FWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 12 (Engine Control System - 2.4L) › Accelerator Position Sensor (APS) › Repair Procedures › Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the upper mounting cap (B), and then remove the mounting nut (C).
  4. Remove the lower mounting cap (D), and then remove the mounting nut (E).
    Fig 1: Removing Upper Mounting Cap
    G12180253Courtesy of KIA MOTORS AMERICA, INC.
    Fig 2: Disconnecting Accelerator Position Sensor Connector
    G12180254Courtesy of KIA MOTORS AMERICA, INC.
About FixVault