Module Power Circuit Inspection
- Ignition "OFF".
- Disconnect FATC connectors.
- Ignition "ON".
- Measure voltage between Pin No. 12 (Memory Power) terminal of FATC connector and chassis ground.
- Measure voltage between Pin No. 23 (ON/START Input) terminal of FATC connector and chassis ground.
- Measure voltage between Pin No. 24 (ON Input) terminal of FATC connector and chassis ground.
Specification: B+
- Is the measured value within specification?
YES
- Go to "MODULE GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit, and then go to "VERIFICATION OF REPAIR " procedure