ECM Neutral Mode Procedure (With Immobilizer)
WARNING: This page is about a different variant/trim than selected.
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform
"ECM Neutral Mode" procedure using KDS.
(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
- After finishing "ECM Neutral Mode", perform
"Key Teaching" procedure using KDS. (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES
")
[If installing a new ECM]
Perform "Key Teaching" procedure using KDS.
(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")