Buzzer Operation Mode

Operation	Request source	Buzzer on/off time	Number of buzzer cycles	Hazard on/off time	Number of hazard cycles	Comment
Start opening	Outside Switch	500/500	2	500/500	2	Delay start of tailgate until first cycle is over
	Inner Switch	500/500	2	500/500	2
	Console Switch	500/500	2	500/500	2
	Remote Key	500/500	2	500/500	2
	Smart Key	500/500	2	500/500	2
Start closing	Outside Switch	500/500	2	500/500	2
	Inner Switch	500/500	2	500/500	2
	Console Switch	500/500	2	500/500	2
	Remote Key	500/500	2	500/500	2
	Smart Key	500/500	2	500/500	2
Outside Switch	500/500	2	500/500	2	No delay (Reversing and buzzing at the same time) - Only delay due to mechanical system
Direct direction change (Open -> Close) (Area: Close - Maximum end point for closing)	Inner Switch	500/500	2	500/500	2	No delay (Reversing and buzzing at the same time) - Only delay due to mechanical system
	Console Switch	500/500	2	500/500	2	No delay (Reversing and buzzing at the same time) - Only delay due to mechanical system
	Remote Key	500/500	2	500/500	2	No delay (Reversing and buzzing at the same time) - Only delay due to mechanical system
	Smart Key	500/500	2	500/500	2	No delay (Reversing and buzzing at the same time) - Only delay due to mechanical system
In manual mode (USM select Input response	Outside Switch	-	-	-	-	-
	Inner Switch	-	-	-	-	-
	Console Switch	-	-	-	-	-
	Remote Key	-	-	-	-	-
	Smart Key	-	-	-	-	-
Obstacle detection (Reverse operation start)	-	500/500	3	-	-	-
Vehicle speeds when tailgate is open	-	500/500	10	-	-	Stop condition Complete 10 times. Tailgate full lock.
Adjust height	Inner Switch	250/250	2	-	-	-
Initialization (Deleting end position and basic position)	Inner Switch & Outside Switch	500/500	1	-	-	-
Initialization (Learning end point)	-	-	-	500/500	2	-
Initialization (During calibration)	-	500/500	Continuous	-	-	-
Tailgate not closed	-	500/500	10	500/500	10	Tailgate closed but lock switch not off (Still open)
Error detect	-	500/500	3	-	-	APS error Spindle error Hall sensor error System error (EEPROM error) Voltage error (Over/Under) PCU error Latch position error Stuck switches. (Switch pressed more than 30 sec) Thermal protection