FixVault
Home › Kia › 2019 › Sorento L › Repair and Diagnosis › External Pages › Different car › Section 126 (Ignition Switch Assembly) › Repair Procedures › Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2020 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel.

    (Refer to Body - "CRASH PAD LOWER PANEL ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to Body - "STEERING COLUMN SHROUD PANEL ")

  4. Remove the wiper switch.

    (Refer to "MULTIFUNCTION SWITCH ")

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the key warning/immobilizer connector (A).
  7. After loosening the screw, remove the key warning switch and key Illumination (B).
  8. If the key lock cylinder (C) needs to be removed, remove the key lock cylinder while pushing the removal/installation button under the key cylinder after turning the key to ACC.
    G12883989Courtesy of KIA MOTORS AMERICA, INC.
About FixVault