FixVault
Home › Kia › 2019 › Soul Base, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 7 (Supplemental Restraint System Control Module (SRSCM) & Sensors) › Front Impact Sensor (FIS) › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the new front impact sensor.
  2. Connect the front impact sensor connector.
  3. Install the front impact sensor mounting bolt.

    Tightening Torque: 

    7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

  4. Reconnect the battery negative cable.
  5. After installing the Front Impact Sensor, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
About FixVault