Power Circuit Inspection
- Ignition "OFF"
- Refer to "ELECTRIC WATER PUMP (EWP) " and disconnect EEWP connector.
- Ignition "ON"
- Measure voltage between Pin No. 7 (Power) terminal of EEWP harness connector and chassis ground.
- Measure voltage between Pin No. 2, 3 (ON/Start Input) terminal of EEWP harness connector and chassis ground.
Specification: B+
- Is measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.