Repair Procedures: Removal

WARNING:

DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake]

Courtesy of KIA MOTORS AMERICA, INC.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the RCV control solenoid valve mounting bolt (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the purge control solenoid valve mounting bolt (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the camshaft position sensor connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the camshaft position sensor (B) after loosening the mounting bolt (A).

Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Exhaust]

Courtesy of KIA MOTORS AMERICA, INC.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner and intake hose.
(Refer to "AIR CLEANER ")
Remove the intercooler inlet pipe & hose assembly (A).
Hose Clamp Bolt:

4.9 - 6.9 N.m (0.5 - 0.7 kgf.m, 3.6 - 5.1 lb.ft)

Pipe Mounting Bolt:

14.7 - 19.5 N.m (1.5 - 2.0 kgf.m, 10.8 - 14.5 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the vacuum hoses (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the low pressure fuel line mounting nut (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the camshaft position sensor connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the camshaft position sensor (A) after loosening the mounting bolt (B).

Courtesy of KIA MOTORS AMERICA, INC.

Courtesy of KIA MOTORS AMERICA, INC.