Repair Procedures: Installation

WARNING: This page is about a different car, the 2019 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
NOTE:
- The shapes of the LH and RH blind-spot detection (BSD) units are different. Therefore, take notice when installing the BSD units.
- After the replacement of BSD unit or bracket or wire, perform the radar calibration procedures. (If do not calibrate the sensor angle, it can cause the malfunction of BSD system.)
  (Refer to Blind Spot Detection system - "BLIND SPOT DETECTION RADAR CALIBRATION ")