FixVault
Home › Kia › 2020 › Stinger GT-Line, AWD › Repair and Diagnosis › External Pages › Different car › Section 40 (Supplemental Restraint System Control Module (SRSCM) And Sensors) › Occupant Classification System (OCS) › Repair Procedures › Installation › Notes

Repair Procedures: Installation: Notes

WARNING: This page is about a different car, the 2019 Kia Stinger. However, it is still accessible from the selected car via links, so may be relevant.

Occupant Classification System (OCS) Unit 

  1. Install the occupant classification system unit on the Front seat track assembly.
  2. Connect the occupant classification system unit connector.
  3. Install the front passenger seat assembly.

    (Refer to " FRONT SEAT ASSEMBLY  ") 

  4. Reconnect the negative battery cable.
  5. After installing the occupant classification system, confirm proper system operation.
    NOTE:
    • Switch "ON" the ignition. The SRS indicator light should turn on for about six seconds and then off.
    • The telltale lamp will be turned "ON" for 4 seconds and "OFF" for 3 seconds. Then, it will remain turned "OFF" as long as the OCS does not require suppression and the passenger airbag is enabled.
    • Be sure to reset OCS with KDS after replacing OCS unit.
About FixVault