Repair Procedures: Installation

Install in the reverse order of removal.
NOTE:
- Do not use already used injector fixing clip again.
- Do not reuse the support disc.
- Do not reuse the injector rubber washer.
- Do not reuse the combustion seal.
- Install the component with the specified torque.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
- Apply engine oil to the injector O-ring.
- Do not use already used injector O-ring again.
- Do not use already used bolt again.
- When insert the injector, be careful not to damage the injector tip.
- Do not reuse the high pressure fuel pipe.