| DTC Strategy |
- Monitor HO2S's signal (Downstream HO2S signal is too low)
|
- Poor connection
- Faulty HO2S
- Clogging of fuel filter in fuel pump
- Faulty ECM
|
| Enable Condition |
- Fuel cut off is not activated
- Full load is not activated (Gas pedal value is less than or equal to 90%)
- Catalyst overheating prevention is not activated
- Battery voltage is between 11V and 16V
|
| Threshold Value |
- Downstream HO2S voltage is lower than 0.75V when lambda set point is equal to 0.8
|
| Diagnostic Time |
- 7s after lambda set point shift to corresponding side
|
| MIL ON Condition |
|