Basic Inspection: Notes
WARNING:
EV battery system uses high voltage.
It may cause death or damage due to electrical shock, if you do not follow below Instructions.
It may cause death or damage due to electrical shock, if you do not follow below Instructions.
- Follow instructions of workshop Service Information.
- Wear and use insulated gloves and tools.
- Ignition "OFF", disconnect ground cable of 12V battery, Open lower-voltage junction block cover which is in PE room and wait 5 minutes after disconnecting A/S interlock. (Blocking high voltage electronic)
- Check high voltage terminal on Power Relay Assembly is lower than 30V.
- Be careful not to allow a short between terminals when measuring battery cell voltage.
You may be injured due to spark, parts damage or electrical shock.
- Metallic material cause high voltage short that may cause damage of life or vehicle. Therefore, get rid of all the metallic material before working. (Metallic Material: Watch, Ring, any metallic products etc.)
- After disconnecting high voltage cable, be careful not to allow a short between exposed terminals on high voltage connector.