FixVault
Home › Land Rover › 1992 › Range Rover Base › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock › Removal & Installation › Stop Light Switch › Removal

Stop Light Switch: Removal

  1. Turn ignition off and disconnect battery negative lead.
  2. Remove lower dash panel. See LOWER DASH PANEL  .
  3. Disconnect electrical connection to switch. See Fig 1 .
  4. Depressurize system. See DEPRESSURIZING SYSTEM  under BLEEDING BRAKE SYSTEM.
  5. While depressing brake pedal, pull Red sleeve (later vehicles, White) and Black plunger of switch FULLY forward. See Fig 1 .
    6. NOTE: If clips are difficult to release, check that Red sleeve is FULLY forward.
  6. Release switch retaining clips. See Fig 1 .
  7. Remove switch. See Fig 1 .
Fig 1: Removing Stop Light Switch
G00067004Courtesy of LAND ROVER NORTH AMERICA, INC.
About FixVault