5.24.1 Description
This input is used as part of the EVAP detection system. The EVAP system diagnostic defaults to enabled if a fuel level sensor fault is detected. If a fault is detected by the ECM if an error message is received from the instrument pack.
Fuel Level Sensor
| Component/System | Fault Codes | Monitoring Strategy Description | Malfunction Criteria | Threshold value | Secondary Parameter | Enable Conditions | Time Required | MIL Illumination | |
|---|---|---|---|---|---|---|---|---|---|
| Fuel level Sensor | P0460 | Electrical Fault | Error message received from the instrument pack | 25 s / continuous | No MIL illumination (leak check defaults to enabled) | ||||
If the above table does not include details of the following enabling conditions: - IAT, ECT, vehicle speed range, and time after engine start-up then the state of these parameters has no influence upon the execution of the monitor.